2. Handle assembly
The dashboard is delivered with one handle disassembled.
The machine handle assembly screws,
gear control fastening screws and nuts and bolts to secure the brush directional control are
delivered in a separate package found in the machine packaging. Install as follows:
a) Install the separate handle to dashboard by fixing two bolts.
b) Bring the two tubes at the ends of the handle (fig. 4.A) up to the support (fig. 4.B).
c) Insert the screws in the holes and secure in place with the nuts.
3. Installation of the gear control
a) Remove the previously assembled articulated joint (fig. 5.A) on the washer gear control (fig. 5.B)
and nut (fig. 5.C).
b) Insert the articulated joint (fig. 5.A) of the gear control in the hole on the lever (fig. 5.D) to
connect it to the transmission.
c) Secure the washer (fig. 5.B) and nut (fig. 5.C).
10
