Feider Machines F405SC3F, Оригинальное руководство пользователя

Страница: 10 / 13

d.
Aligning the angle pointer
Loosen the table and the pointer and
adjust with a square (not supplied) until
a perfect angle is obtained with the
blade and table. Then tighten the table
and the pointer screw.
e.
Installing/replacing and adjusting the blade
- Turn the
tension knob counter clockwise to release the saw blade.
- Unscrew the left cover.
-
Press lightly on the protective support to remove the blade out of the top blade holder.
Then take the blade out of the bottom blade holder. Pull the blade up and out through the
table.
-
Insert the new blade, the teeth must be downwards so as not to cause a clattering on the
table and in front of the workpiece.
- Use the Allen key to clamp-fit the saw blade in the holder.
- Finally, perform the reverse routing to tighten the screws
Handle the blades thoroughly to avoid any risk of accidents.
f.
Using the speed adjustment button
To vary the speed, turn the speed
controller knob (1). To increase the speed,
turn the knob to the right, to decrease the
speed turn the knob to the left.
Tips: For straight cuts, use a fast speed,
for the winding cuts adjust a slower speed.
g.
Installation of the mini drill hose
-
To install the mini-drill hose (1 meter), align the hose
with the mini-drill coupling located on the right side of
the machine.
-
Once aligned, tighten firmly.
h.
Installation of a new accessory
With the flexible shaft lock pressed down, tighten the compression nut.
Release the flexible shaft spindle lock by sliding it towards the accessory.