Feider Machines F405SC3F, Оригинальное руководство пользователя

Страница: 12 / 13

5.
MAINTENANCE AND STORAGE
a.
Cleaning of chips
When using your machine it is important to connect a vacuum cleaner connected to the
chip outlet so that the chips do not remain in the motor or in the chassis of the machine.
Chip accumulation can alter the drive belt and cause the engine to overheat. These
failures are not covered under warranty
b.
lubricating of the gooseneck supports
Lubricate this part with white oil as often as possible (about
every 2 hours of use).
c.
Regular maintenance
Periodically check the power cable and, if it is damaged, replace it with an identical cable.
It is recommended that this service be carried out by the After Sales Service.
Periodically check the power cord and extension cables and replace if damaged. This
operation must be provided by a qualified service.
Keep the ventilation slots of the machine always in good condition.
It is advisable to check the condition of the carbon brushes after 50 hours of use or in
case of excessive sparking.
Keep the cutting tools sharp and clean for better and safer performance.
Clean the protector with a brush to remove sawdust after use after disconnecting the
machine.
The cleaning of the plastic parts is done disconnected machine, using a soft damp cloth
and a little soft soap.
Never immerse the machine and do not use detergent, alcohol, gasoline, etc.
For thorough cleaning, consult the After Sales Service.
6.
DISPOSAL
Electrical products should not be discarded with household products. According to the
European Directive 2012/19/EU on waste electrical and electronic equipment and its
implementation into national law, electrical products used must be collected separately and
disposed of at collection points provided for this purpose. Talk with your local authorities or
dealer for advice on recycling.