Feider Machines F405SC3F, Оригинальное руководство пользователя

Страница: 11 / 13

4.
UTILISATION
a.
Inserting the workpiece
-
Adjust the protection and the slide according to
the size of the workpiece.
-
Tighten the screws and fasteners.
-
Push the guard up to the cutting slide.
-
Any unused blade must be protected!
-
Switch the machine on firmly.
-
Place the workpiece on the entry table.
-
Progress the workpiece progressively with the
cutting line facing the cutting edge of the blade.
Caution, moving the workpiece too fast generates
burrs or breakage of the blades.
You can also make interior cuts without having to
cut your piece from an edge.
b. Starting
After adjustments and checks, start the machine by pressing the green button (1) of the
disconnection switch.
Run the machine for 30 seconds in a safe position to check for proper operation.
Stop the machine immediately if there is a significant vibration or if other defects are
detected.
If this is the case, check the machine to determine the cause of the fault.
Stopping is carried out by pressing the red button on the magnetic switch 2).
c. Use
You can use the machine after unpacking, reading the instructions and checking the
correct assembly of the blade.
For a good sliding, the table must be regularly lubricated.
Avoid wet wood.
Carefully remove and clean wood chips regularly.
Avoid working too small parts (less than 5 mm thick).
Caution: moving the workpiece too fast generates burrs.