4
IMPORTANT SAFETY INFORMATION
This terminal has been designed to meet international safety standards but, like any
electrical equipment, care must be taken if safety is to be assured. read these safety
instructions before installation and operation of the terminal. Retain this installation guide
for future use.
DO
ensure that all the electrical connections (including power
connections and interconnections between pieces of equipment) are
properly made in accordance with the manufacturers instructions.
Equipment provided with a safety earth connection must be
earthed.
DO
consult your dealer if you are in any doubt about
installation, operation or safety of the equipment.
DO
remember that some equipment continues to operate after
mains power has been removed, because of an internal battery. In
such cases a qualified Service Engineer must disconnect the
battery before attempting to service the equipment.
DO NOT
continue to operate the equipment if you are in any
doubt about it working normally
DO NOT
remove any cover fastenings unless you are qualified
to do so. Even then isolate from the power connection before you
start.
DO NOT
allow the equipment to be exposed to rain or moisture
other than permitted by the equipment's specification.
DO NOT
attempt to service any battery fitted to the equipment.
If the battery fitted to the circuit board is faulty, return the complete
circuit board to an approved Service Centre. Removable batteries
may be replaced by a qualified Service Engineer
WARNING...
To comply with international safety standards the a.c. supply must be
routed via an easily accessible isolating device. This device must have a contact gap of
at least 3mm (three millimetres) and should break both Live and Neutral conductors
simultaneously. If the Neutral conductor can be reliably identified the device may be in
the Live conductor only.
POWER REQUIREMENT...
The TR
-
1000 terminal is supplied with an internal 12V
6W supply with an external mains connection. The power supply is overload protected
and the terminal includes circuit protection against over
-
voltage and reverse connection.
GENERAL INFORMATION
