Federal ITR Series, Инструкция по установке и эксплуатации

Страница: 57 / 64

- 57 -
Pre-Service Checklist
You may avoid the cost and inconvenience of an unnecessary service call by first reviewing this
checklist of frequently encountered situations that can cause unsatisfactory case performance.
CAUTION: Before servicing case turn off power at the main breaker of fuse
box.
Case Does Not Operate
-Check for disconnected power supply.
-Check for tripped breaker or blown fuse.
-Check that power switch is on.
Lights Do Not Operate
-Check that light switch is on.
-Be sure light cord is properly seated into LED light strip.
-Is the light cord plugged in to light strip upside down.
Case Temperature Too Warm
-Check that the cold air inlet and outlet slots are not blocked.
- Be sure that the rear doors are closed and tightly sealed.
-Check for a blocked or dirty condenser coil fins.
-Check cold airflow. Lack of adequate cold airflow could be a defective evaporator fan or
blocked evaporator coil. Check that paper or foreign material is not blocking evaporator.
If the evaporator coil is blocked due to excessive frost, initiate a manual defrost on the
electronic temperature control as described in the Using Electronic Temperature Control
section of this manual.
-Is the case installed properly to allow adequate air flow to and from condenser?
-Check that the electronic control settings are correct.
-Check environment conditions. This case is designed to operate in no more than 80 degree
55 percent humidity.
SALE & DISPOSAL
Owner Responsibility
If you sell or give away your Federal Industries case you must make sure that all safety labels and
the Installation-Service Manual are included with it. If you need replacement labels or manuals,
Federal Industries will provide them free of charge. Contact the customer service department at
Federal Industries at (800) 356-4206.
The customer service department at Federal Industries should be contacted at the time of sale or
disposal of your case so records may be kept of its new location.
If you sell or give away your Federal Industries case and you evacuate the refrigerant charge before
shipment. Federal Industries recommends that the charge be evacuated into a recovery system to
prevent the possibility of HFC’s from being released into the atmosphere.