Federal ITR Series, Инструкция по установке и эксплуатации

Страница: 55 / 64

- 55 -
8. Remove the evaporator fan shroud by removing the thumbscrews along the backside of evaporator
fan shroud and the (2) thumb screws on each side of evaporator coil. Unplug fan(s) from wire
harness and remove evaporator fan shroud with fan attached from case.
9. Clean the entire interior of the case using warm soapy water. Wipe off all soapy water with a damp
cloth and allow to dry.
10. Clean all shelves, shelf support bars, shelf standards, shelf brackets, and display deck using warm
soapy water and a brush. Rinse thoroughly and allow to dry.
11. Clean behind front glass hinge using warm soapy water and sweeping debris to each end and
12. Clean all foreign material from inner and outer rear door tracks using warm soapy water and a
brush. Apply a light film of lubricant such as PAM to make the doors operate smoother.
13. Clean both sides of the doors, end glass and front glass using any common window cleaner.
IMPORTANT: Do not allow glass cleaner to contact any of the Acrylic front deflector, front
lift-up doors, and plastic inner doors. The front glass can be tilted forward to allow easier access to
clean interior. Tilt the front glass out by grabbing the top edge of glass with finger tips and pulling it
away from magnetic strips on case. Tilt glass until it stops at about 30 degrees angle.
IMPORTANT: Hold on to the glass until it stops and do not let it free fall or damage to glass or
hinge may occur. Close the glass by pushing glass back up against magnetic gasket in closed
position.
14. 1IMPORTANT: Cleaning the Acrylic plastic front deflector, front lift-up doors, and plastic inner
doors require special care to prevent hazing and yellowing of material. Lightly dust (not wipe)
surface with clean soft cloth. Then the surface can be wiped carefully with a soft, wet cloth or
chamois. The cloth or chamois must be kept free of grit by frequently rinsing in clean water. Grease
and oil can be removed with kerosene. Do not use window cleaners or kitchen scouring compounds.
DO NOT use solvents such as Acetone, Benzene, Carbon Tetrachloride, and Lacquer Thinners. A
spray wax such as Pledge or Maguire’s polish can be applied and wiped with a clean soft cloth. The
wax tends to fill in and hide small scratches.
15. Reassemble the case in reverse order.
Weekly Exterior Cleaning All
1. Clean the front, end glass and rear doors using any common window cleaner. IMPORTANT: Do
not allow glass cleaner to contact any of the Acrylic front deflector, front lift-up doors, and plastic
inner doors.
2. The exterior surfaces should be wiped down using any ammoniated cleansers or warm soapy water.
3. Clean the Acrylic plastic front deflector requires special care to prevent hazing and yellowing of
material. Lightly dust (not wipe) surface with clean soft cloth. Then the surface can be wiped
carefully with a soft, wet cloth or chamois. The cloth or chamois must be kept free of grit by
frequently rinsing in clean water. Grease and oil can be removed with kerosene. Do not use window
cleaners or kitchen scouring compounds. DO NOT use solvents such as Acetone, Benzene, Carbon
Tetrachloride, and Lacquer Thinners. A spray wax such as Pledge or Maguire’s polish can be
applied and wiped with a clean soft cloth. The wax tends to fill in and hide small scratches