Valor
®
Light Bar Hook-On Mounting Kit Manual
6
Valor Hook-On Mounting Kit
Federal Signal
www.fedsig.com
5.
Tighten all eight 5/16-inch Torx pan screws that fasten the adjustable foot brackets to the mounting feet.
6.
To fasten the mounting hook, refer to the keeper plate instructions (Federal Signal P/N 2561635) included
in the supplied Keeper Plate Kit.
IMPORTANT:
Frequently inspect the light bar assembly to ensure that all fasteners and brackets are tight.
Figure 4 Light bar mounted on vehicle roof
5/16-18 PAN
TORX SCREW (8)
LED ALLEY LIGHT
ADJUSTABLE FOOT
BRACKETS (4)
#10 TYPE B PAN
TORX SCREW (4)
LH MOUNTING FOOT
290A6445
SLOTS FOR LEVELING
LIGHTBAR AND
ADJUSTING HEIGHT
FOOTPAD (4)
Aiming the Optional HotFoot LED Takedown Lights
The optional HotFoot LED takedown lights are factory installed and wired. The horizontal aim of the takedown
light is adju/– 10 degrees. See Figure 5.
Figure 5 LED HotFoot takedownl light
LED TAKEDOWN LIGHT
10-32 PAN TORX SCREWS
290A6446
To aim the takedown lights:
1.
Loosen the 10-32 pan Torx screws securing the lights.
2.
Reposition the lights and tighten the screws.
