7
Mounting the Light
Model QL73LEDSCENE
Federal Signal
www.fedsig.com
Mounting the Light
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in
the deployment path of an airbag. Failure to observe this warning
will reduce the effectiveness of the airbag or potentially dislodge
the equipment, causing serious injury or death.
Before proceeding, determine the approximate location of the light
assembly and plan all cable/wire routing.
IMPORTANT:
For maximum coverage and effectiveness, the
light assembly must be mounted in a horizontal orientation. (See
Figure 1 on page 9.)
To mount the scene light:
1.
Position the light assembly the mounting surface. Ensure that
the light is level side to side.
2.
Using the dimensions provided in Figure 2 on page 10,
scribe the four mounting hole locations and a wiring routing
hole location on the mounting surface.
DRILLING PRECAUTIONS: When drilling holes, check the area
you are drilling into to ensure that you do not damage vehicle
components while drilling. All drilled holes should be de-burred,
and all sharp edges should be smoothed. All wire routings going
through drilled holes should be protected by a grommet or
convolute/split loom tubing.
3.
Drill four 1/4inch mounting holes and a wire routing hole 1inch
at the scribed locations.
4.
Install the four supplied screw grommets into the four 1/4inch
mounting holes.
5.
Complete the electrical connections as described in “Wiring the
Light” on page 11.