HEAD
ASSEMBLY
GLOBE
GASKET
LAMP
FIXTURE
BASE
SET SCREW
(3 PLACES)
NOTE : ROOF AND LAMP STYLE WILL VARY WITH FIXTURE OPTIONS.
1. WARNING : TURN THE POWER OFF BEFORE
INSTALLING OR PERFORMING ANY
MAINTENANCE ON THIS FIXTURE. Failure
to do so may result in severe injury
or death.
2. GFI PROTECTION! Fixtures which may
come in contact with or be exposed
to moisture (i.e. outdoors) shall
be installed on a GFI (Ground Fault
Interruptor) circuit.
3. The fixture should not be installed
in low lying areas or where water
may accumulate and stand for long
periods of time.
CAUTION
INSTALLATION
1. WARNING : Make sure the power is off
before installing or servicing this fixture.
2. Install the anchor rods into a concrete
footing as indicated on the supplied
template. Install and level the twistlock
baseplate with ballast assembly as
shown on the template.
3. Connect the supply lines from the supply conduit to the fixture's inputs. Tie the wires so they do not
lie on the ground. Connect the lamp supply quick-connect to the receptacle on the ballast bracket.
4. Set the fixture onto the twistlock baseplate using the "Align Screw" mark shown on the baseplate to
orient the fixture. Be sure not to crimp any wires in the twistlock.
5. Turn the fixture clockwise about 1/8 turn until hand tight. Tighten the set screw to lock it in place.
6. Install a lamp per the relamping instructions below and test the fixture for proper operation.
RELAMPING
Make sure power is off before relamping. Loosen the three set screws on the bottom louver by about 1/2"
each. Lift the head of the fixture off, holding it by the louvers, not the roof. Lift the globe straight off.
Make sure the gasket stays tightly on the globe. Replace the lamp or install a new one per the lamp style
on the lamp label. HID fixtures should use coated lamps for best results. Note that if the house side shield is
needed, it should be inserted into the globe at this time. Replace the globe, positioning the house side
shield (if used) to cut off light in the desired direction. Set the head onto the fixture. Hold the head down
and tighten the three set screws.
32000897, revision D
100 Craftway, P.O. Box 128
Littlestown, Pennsylvania 17340-0128
Phone: 800-331-4185 Fax: 717-359-9672
INSTALLATION INSTRUCTIONS:
CL8 - 8" CAST LOUVER
BOLLARD
This fixture is intended for installation in accordance with the National Electrical Code and local code
specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage
to the ballast and void the warranty. These instructions do not purport to cover all details or variations in
equipment, nor to provide for every possible contingency related to installation, operation, maintenance,
or mounting situation. Should specific problems occur that are not addressed by these instructions, contact
your Sales Representative or distributor for assistance. Retain these instructions for future reference.
page 1 of 2
