20
Informer Series Tone Alert Receiver
Training
MERGEFORMAT
Configuring
the
Informer-IPFORMAT
General
Description
ations
3.
Remove the four screws located at the four corners of the Informer TAR.
4.
Remove the bottom cover of the Informer TAR.
5.
Pull the battery out of the Informer.
IMPORTANT
:
Do not touch the PCB or to pull the battery wires off the PCB.
6.
Grasp the positive (+) battery terminal firmly and remove from the battery.
7.
Grasp the negative (-) battery terminal firmly and remove from the battery.
8.
Connect the battery terminals to the new battery. Ensure the red wire is connected
to the positive (+) terminal and the black wire is connected to the negative (–)
terminal of the battery.
9.
Place the new battery into the Informer TAR in the same position as the battery
just removed.
10.
Replace the bottom cover and the four screws. Do not over-tighten the mounting
screws.
11.
Plug in the power supply.
12.
Test the Informer TAR as described in the installation section of this manual.
Batteries installed shall not be exposed to excessive heat such as
sunshine, fire or the like.
