12
Informer Series Tone Alert Receiver
Installation Instructions
MERGEFORMAT
Configuring
the
Informer-IPFORMAT
General
Description
ations
Wall Mounting
Wall mounting is the preferred mounting method for the Informer TAR. Before
mounting the unit, determine a suitable location considering the criteria listed
previous. The Informer TAR has two keyholes located on the bottom of the unit that
accepts #8 screws. Place the mounting screws horizontally level, approximately
6 inches above eye level and four (4) inches apart on center. Ensure the screws are
placed into material that can adequately support the weight of the Informer TAR. Use
a #8 wall anchor when mounting to drywall. Ensure that the screws are tightened
sufficiently to securely fasten the Informer against the wall.
Figure 1 Informer TAR Rear View
Mount the local rubber antenna vertically on top of the Informer TAR (not bent at
90°) so that the antenna is pointed toward the ceiling. If you require an external
antenna, have it installed by a qualified electrician in accordance with local and
national electrical codes.
Run the 9 VDC power supply against the wall and plugged into a 120 VAC, 60 Hz
outlet. Plug the low voltage end of the cord into the power jack located at the rear of
the Informer TAR. Route the cord to ensure it is protected against walking on,
tripping over or pinching the cord. Turn the battery switch to the on position. Refer to
the “Using the Battery Switch.”
Desk Mounting
Before installing the Informer TAR, determine a suitable location considering the
criteria listed previous. Bend the local rubber antenna at 90° so the antenna points
toward the ceiling. If you require an external antenna, it should be installed by a
qualified electrician in accordance with local and national electrical codes.
Run the 9 VDC power supply against the wall and plugged into a 120 VAC, 60 Hz
outlet. Plug the low voltage end of the cord into the power jack located at the rear of
