Federal Signal Corporation Informer I-HIOW, Инструкция по установке и эксплуатации

Страница: 8 / 30

4 Informer Wall Mount Series
General Description
MERGEFORMAT Configuring the
Informer-IPFORMAT General
Description ations
Features

Available in two (2) frequencies bands: VHF 150-170 MHz and UHF
450-470 MHz

Long life rechargeable battery with built-in charger (Only units built after May
2015 are equipped with a battery.)

Wide temperature operating range

Excellent RF sensitivity and selectivity

Fully programmable RF—no tuning required

Clean, low distortion of recovered audio

Loud +80 dBA output at 10 feet

Signal to Noise based squelch circuit, does not open receiver in high radio noise
environments; that is, near computers, etc.

Programmable for wide or narrow band

Programmable RF, Single Tone, Two-Tone, DTMF, CTCSS, and CDCSS (DPL)
decoding

Re-programmable over RS232 port

Volume control, Monitor, and Reset buttons with diagnostic LEDs
Optional Features

Programmable MSK decoder compatible with the Federal’s Commander
Software.

Programmable EAS decoder for decoding NOAA radio SAME code alerts.

600 Ohm audio output and two (2) SPDT relay outputs.

Windows XP/Vista/7
®
based programming software.

Ability to top mount Model LP1-012 12 V mini-strobe when used in Wall Mount
configuration. Strobe does not function during battery backup mode.
NOTE
: The MSK and EAS decoders are not available simultaneously in the same
unit. You can use all other options together.