6
Installation and Maintenance Manual
LP800 Solaris Beacon
Federal Signal
www.fedsig.com
connected. Strobe systems can hold their charge even after
they have been turned off. After disconnecting power to the
unit, wait 5 minutes before handling any parts of the strobe
system.
• A light system is a high current system. For the system to
function properly, make a separate negative (–) connection and
positive (+) connection. Connect all negative connections to
the negative battery terminal and install a suitable fuse on the
positive battery terminal connection as close to the battery as
possible. Ensure that all wires and fuses are rated correctly to
handle the device and system amperage requirements.
• In order for the light head to function properly, make a separate
ground connection. If practical, connect to the negative battery
terminal. At a minimum, attach to a solid metal body or chassis
part that provides an effective ground path as long as the
equipment is to be used.
• Never attempt to install aftermarket equipment that connects
to the vehicle wiring without reviewing a vehicle wiring
diagram available from the vehicle manufacturer. Ensure that
your installation will not affect vehicle operation or mandated
safety functions or circuits. Always check the vehicle for proper
operation after installation.
• The lighting system components, especially light bulbs, strobe
tubes, LEDs, and the outer housing, get hot during operation.
Disconnect power to the system and allow the system to cool
down before handling any components of the system.
• Do not mount a radio antenna within 18 inches (45.7 cm) of the
lighting system. Placing the antenna too close to the lighting
system could cause the lighting system to malfunction or be
damaged by strong radio fields. Mounting the antenna too close
to the lighting system may also cause the radio noise emitted
from the lighting system to interfere with the reception of the
radio transmitter and reduce radio reception.
• Do not attempt to wash any unsealed electrical device while it is
connected to its power source.
