17
Installation and Maintenance Manual
LP800 Solaris Beacon
Federal Signal
www.fedsig.com
Cleaning the Lens
Polycarbonate and ABS parts
To extend the life of this product, Federal Signal recommends
periodic cleaning using correct methods and cleaners. For
general cleaning, do not use an abrasive cleaner or highly
alkaline. Furthermore, do not scratch the plate with a rubber
brush, razor blade, or with other sharpened instrument. Do not
clean polycarbonate and ABS parts under strong sunlight or high
temperatures, as this could cause staining.
To clean this product, apply warm water and wash it with neutral
pH soap. Use a soft cloth or sponge to remove any remaining dirt.
Finally, rinse with cold water and dry with a soft cloth to avoid water
spots.
Should fine scratches or a haze appear on the lenses, remove with
a nonabrasive, high quality, one-step automotive paste cleaner/wax
and a soft cloth.
CRAZING HAZARD: Crazed, cracked, or faded domes or reflectors
reduce the light output and the effectiveness of the lighting system.
Tops or reflectors showing this type of aging must be replaced.
Failure to follow this warning may result in bodily injury or death to
you or others.
CLEANING SOLUTION WARNING: The use of cleaning solutions,
such as strong detergents, solvents, and petroleum products, can
cause crazing (cracking) of the domes and reflectors. Failure to
follow this warning can damage the domes and reflectors and may
result in bodily injury or death to you or others.
Replacing the Dome
To replace the dome:
1.
Disconnect unit from power source and remove unit from
mounting surface.
2.
Turn unit over and remove the three large head Phillips screws.
3.
Separate dome from base. Discard or recycle old dome.
