- 30 -
DISPLAY DECK
FAN SHROUD ASSEMBLY
PLASTIC AIR DEFLECTOR
FAN SHROUD ASSEMBLY
RETAINER LATCH
HONEYCOMB AIR
DIFFUSER
1.
If supplied with lower rear door option remove both inner & outer rear doors as described in the
“Door Removal” section of this manual.
2.
Clean all foreign material from inner and outer rear door tracks and clean both sides of the doors
using warm soapy water and a brush. Apply a light film of lubricant such as PAM to door tracks to
make the doors operate smoother.
3.
If supplied; remove interior shelving or display steps from unit as described in the “Shelving
Installation and Removal” section of this manual.
4.
Clean all shelves, shelf support bars, shelf light housings, shelf brackets, shelf standards and
display steps using warm soapy water and a brush. Rinse thoroughly and allow to dry.
5.
Lift the display deck(s) up and out of evaporator tub.
6.
Remove the fan shroud assembly. There are either (2) retainer latches or (2) thumbscrews located
at each end at the front of the fan shroud. Lift the black tab up on each retainer latch or remove the
(2) front thumbscrews. Detach the rear of the fan shroud from the case by removing the thumb
screws from along the rear lip of the fan shroud. Lift the fan shroud assembly and reach in and
unplug the evaporator fan motor cord(s). Lift the fan shroud assembly out of the tub.
7.
Clean the display deck(s) using warm soapy water and a brush. Rinse thoroughly and allow to dry.
Wipe off fan shroud assembly (do not rinse or submerge fan motors).
8.
Clean the entire interior of the case using warm soapy water. Wipe off all soapy water with a
damp cloth and allow to dry. (DO NOT use solvents such as Acetone, Benzene, Carbon
Tetrachloride, and Lacquer Thinners)
ESSRC
All manuals and user guides at all-guides.com