- 12 -
5.
Remove the cap from the appropriate female light sockets.
IMPORTANT:
Grip each side of cap firmly and wiggle and pull cap straight out of socket. Do not roll
cap during removal. Incorrect removal of cap may cause damage to electrical connection.
RIGHT
WRONG
6.
If the socket is not being used for a shelf light, the cap must be plugged into the socket. On models with
the 5 pin shelf plug, this is necessary for the entire light system to operate. On models with the 3 pin
shelf plug, this is necessary to prevent buildup and damage to receptacle.
7.
Plug in each shelf light by aligning the male pins on the appropriate shelf light cord plugs with the
female light sockets and push together.
IMPORTANT:
Do not roll plug during insertion.
8.
Hang one end of the shelf support on to the rear notch of one shelf bracket and then on the rear notch of
the shelf bracket on the opposite side. NOTE: If the bottom open section shelf is supplied instead of
step risers, the bottom rear support is not the same as the top rear support. See illustration above.
9.
Place supplied shelving onto shelf supports as outlined in the appropriate “Shelf Installation” section of
this manual.
10.
Removal of shelving is performed by following steps in reverse order.
11.
The shelf standards are removable from case by removing the (2) shelf standard retaining screws
holding them to the inside wall of case.
Wire Shelves Installation
WIRE SHELF
WIRE SHELF
RETAINER CLIPS
SNAP THE REAR RAIL OF
THE WIRE SHELF INTO
RETAINER CLIPS ON
REAR SHELF SUPPORT
1.
Install shelf brackets & shelf supports as described in Shelf Bracket & Supports Installation Section of
this manual.
2.
Place the front of wire shelf onto front shelf light or front shelf support.
3.
Snap the rear of shelf into the clear plastic clips on rear shelf support.
All manuals and user guides at all-guides.com