- 19 -
4.2 Turning off the UPS
Please be sure to perform the following operations even during planned
power outages. (For details, see "5.2 Precautions and Countermeasures
for Planned Power Outages")
3. Output stops
The [RUN] LED (green) on the front of the UPS flashes slowly (cycles of
1.6 seconds).
If output does not stop normally, refer to "Chapter 7 Troubleshooting".
4. Turn off the input breaker on the back of the UPS.
Type: M-UPS***ADS
Status: Stand by
Input: ***.*:V **.*Hz
Output: ***.*:V **.*Hz
Press the ON/OFF
switch for one second.
CAUTION
Damage
Refer to "4.2 Turning off the UPS" when:
a)
Performing planned power outage or,
b)
Turning off the input breaker on the back of the UPS
See that the RUN LED (green) is blinking slowly (1.6 second cycle).
Do not unplug the AC input plug from the power outlet or turn off
the input breaker on the back of the UPS without turning off the
UPS. Otherwise it will cause a power failure, which will discharge
the internal battery.
This may cause the battery to deteriorate and shorten the battery
replacement cycle.
1.
Turn off the connected device
2.
Press the [ON/OFF] switch for
1
second. The buzzer will sound when
it
is off.
