Page 15 of 35
Rev. 1.03
WARNING: IMPORTANT NOTES FOR THE START UP OF THE CONTROL PANEL
All the zones and siren outputs must have to connect the end of line resistors (for your values
to see
PART 9). At first activation of the control panel, to connect the power supply and after
the batteries.
To verify that the start test has not faults.
4.1 DEFAULT SETTING
At first time the control panel has the following setting:
1) all zones are in service (no out of service);
2) all zones are in alarm mode (single consent) and the “Automatic activation” property of
the <
Out1
> output is disabled (see chapter
7.3.1);
3) the siren output delay is set up on zero seconds (0s).
The control panel programming remains in the memory, also if the control panel is off. If the
user wants to restore the default parameters, it is necessary to do a 2
nd
level reset (see the
chapter
6.8).
PART 4
RAPID PROCEDURE OF CONFIGURATION CONTROL
PANEL
