FCI ASD-0003, Руководство по установке

Страница: 7 / 20

P a g e | 7
Construction /
Installation Diagram
1. Faucet Soap Assembly
i.
Soap Dispenser oftentimes can be
mounted in the left or right hole of a
100 m or 200 mm center-set sink.
The ability to do this is contingent
upon the width of the faucet spout
and accessibility to the unit on the
underside of the sink (the Motor
and Soap Bottle cannot interfere
with the water or drain lines). When
such interference above or below
the sink occurs, the Soap
Dispenser must be installed
through the countertop to the side
of the sink as shown in figure 1.
ii.
Drill a 25
– 30 mm hole into the
counter.
iii.
Slide the plastic gasket onto the
brass shank making certain that the
hole in gasket is positioned over the
washer in the base of the spout.
iv.
Guide the brass shank, tubes and
the sensor cable through the hole in
the counter.