FCC BBQ CHEF'S SUPREME 4.1, Руководство пользователя

Страница: 23 / 30

G A S L E A K T E S T
!
!
GAS LEAK TEST
1.
Extinguish all live flames, heat sources and cigarettes in the area where
the leak test is to be performed.
2.
Turn all controls on the barbecue to the OFF position.
3.
Set the regulator to the OFF position and connect it to the gas cylinder.
4.
Spray the leaking spray (or brush the soap mixture) on all joints and connections on the gas
cylinder, regulator, the entire hose and all valves on the barbecue.
5.
Open the gas supply on the regulator and carefully check for bubbles
in any of the places where the spray mixture is applied.
6.
IF BUBBLES OCCUR, CLOSE THE GAS SUPPLY AND TIGHTEN ALL CONNECTIONS/
JOINTS. THEN DO A NEW TEST.
THE BARBECUE MUST NOT BE USED UNTIL YOU ARE SURE THERE ARE NO LEAKS.
GAS LEAK CAN CAUSE UNCONTROLLED FIRE WHICH MAY INJURY PERSONS,
FIXED INSTALLATIONS AND YOUR BARBECUE.
7.
If detected leakage cannot be rectified, do not attempt to cure leakage but consult your
dealer or FCC BBQ Products support at support@fccbbq.com for help in solving the
problem.
!
BEFORE USING THE BARBECUE, A LEAK TEST MUST BE CARRIED OUT!
●
LEAK TEST MUST BE DONE REGULARLY AND EVERY TIME THE GAS
CYLINDER, REGULATOR OR HOSE IS REPLACED.
●
ALSO TEST BEFORE NEW GRILL SEASON AND IF THE BARBECUE HAS
NOT BEEN USED FOR A WHILE.
NEVER CHECK FOR LEAKS BY USING AN OPEN FLAME! USE A LEAK SPRAY
OR ALTERNATIVELY A SOAPY WATER MIXTURE
(TWO PARTS DISHWASHING SOAP AND ONE PART WATER).
Leak spray
!
23