FBII XL-20, Руководство пользователя, Страница: 12 / 28

XL-20 Owner’s Manual - Page 10
BYPASS
Bypass excludes a zone of protection from the security system until it is
unbypassed or until the next time you disarm the system. Bypassing can only be
done while the system is turned off.
Press the Bypass Button followed by your user code and then the Zone # (1-8) to
be bypassed.
ZONE #
If Quick Bypass is enabled, you need only to press the Bypass button and the
Zone #.
NOTE: Bypassed zones are not protected when the system is turned on. After the
bypass command has been accepted the keypad will sound one long beep and the
zone or zones bypassed will slowly blink.
NOTE: Temporary users (i.e. baby sitters, housekeepers, etc.) should not be
shown the Bypass procedure.
UNBYPASS
Unbypass returns a bypassed zone to normal operation.
Unbypass is a repeat of the bypass function.
ZONE #
After unbypassing the zone display will show the state of the zones.
* Code is not required if your system was programmed with quick bypass.
TURN THE SYSTEM OFF
When you turn off the system you turn off only the burglar portion of your
system, any smoke or heat detectors and panic buttons will remain on. You must
enter through a designated entry door and turn off the system within the time
allowed. You can have different amounts of time for different entry points. See
your system reference sheet for the times established for your system.
Enter your four digit user code.
If no alarms have taken place, the On/Off light (labeled arm) will go off.
BYPASS
User Code *
BYPASS
User Code *