- 13 -
Arming the System (Cont’d)
TO ARM THE SYSTEM IN INSTANT MODE
In INSTANT mode, all alarm sensors, including doors that normally have a
delay to allow you to disarm the system, will report an alarm immediately if
activated. Check to make sure the system is ready. When it is ready, press:
INSTANT
followed by your user code.
When the system has been armed successfully, the ARMED light and the
INSTANT light will be on, and the following will be displayed:
LCD Keypad:
ON: INSTANT
PART 1
Fixed-Word Keypad:
INSTANT
LED Keypad:
“Arm” and “Instant”
LEDs lit
TO BYPASS A ZONE
The Bypass function excludes a zone of protection from the security system
until it is unbypassed (either by using the unbypass procedure or when you
disarm the system). Bypassing can only be done while the system is
disarmed.
NOTE: 24-hour zones may be bypassed, but can only be unbypassed if the
zone is not faulted (condition has been cleared).
Press the BYPASS button. Then enter your user code and the zone number
(01–24) to be bypassed, as follows:
BYPASS
followed by your user code
†
+
ZONE NO.
†
If the Quick Bypass feature has been enabled by the installer, do not enter
the user code when bypassing zones.
NOTE: Bypassed zones are NOT protected when the system is armed. After
the bypass command has been accepted, the keypad sounds one long beep,
and the following will be displayed:
LCD Keypad:
BYPASSED: ZN 01
FRONT DOOR
Fixed-Word Keypad:
BYPASS
zone number displayed
LED Keypad:
Zone LEDs of the
zone(s) bypassed slowly
blink
