FBI FM, Инструкция по эксплуатации и техническому обслуживанию

Страница: 8 / 12

8
7. USE CONDITIONS
7.1 Foreseen use conditions
The oven has been designed for welding electrode keeping treatments.
Any other use, different from what indicated by the producer, could be hazardous for the operator.
The supply power cables must be disconnected during the oven displacement.
Handle the oven using the relevant eyebolts and a suitable lifting device.
The oven has to be placed in a safe area, protected against mud, water and sheltered from rain
and humidity. The unit cannot be used in the open air.
The oven door can be locked (lock not supplied) to avoid opening the door during the drying
process.
We suggest the assignment of an electrode treatment manager to insure the proper treatment of
electrodes.
The operator should wear the appropriate attire with all safety devices when opening the oven.
Never access the oven during the drying process because of the very high temperature.
The keeping oven is only designed and manufactured for specific function. Be sure to use all of the
safety devices supplied or suggested by the manufacturer.
Any modification to the oven and relevant accessories is forbidden.
Always remember that electricity is applied to the oven even if the thermostat is OFF.
7.2. Not allowed use
Do not store or heat liquids.
Do not tamper with electrical circuitry of the oven.
Do not leave the air snorkels closed during the drying cycle (their opening improves air
circulation)
Do not use the oven at the open air and exposed to weather inclemencies.
Do not use the oven without the appropriate safety devices and without grounding.
When the oven has to be controlled, please switch the main power switch off, before operating.
In case of fire, do not use liquid or foam fire extinguisher.
8. DISASSEMBLY AFTER USE
When the utilisation is completed, switch the main power supply off and remove the remaining
electrodes putting them in a keeping oven. Then switch the main power switch off for
disconnecting power, putting it on “0” position. Disconnect the main power tension.
If the electrodes have soaked up humidity, provide for a new dryer treatment before using
them again.
9. DISMOUNTING INDICATIONS
9.1 General indications
Do not waste the oven in the ambient.
Make a separation of the components selecting by category for a possible reuse or separate
waste.
In any case please refer also the local regulations about waste.