DIGITAL MERCHANDISER
56X/77X MODELS
6
4.3 Installation of 77x Multiple Barrel Merchandisers (2-, 3-, or 4-Barrel)
4.4 Installation of a Digital Merchandiser with Conversion Kit
Installing a new digital merchandiser on a dispenser that was sold with a non-digital merchandiser requires various internal
changes to the dispenser. The conversion kit sold with the digital merchandiser will have all required components for the
change. Please refer to the install instructions included with the conversion kit for detailed instructions. If instructions are
missing from the conversion kit, please contact Customer Service and ask for these using the part numbers below.
Door
3.
While holding up the door, push the gas shock socket from the door into the ball
stud on the front facing bracket. Repeat on the opposite side (
Figure 4.12
).
4.
Connect the power harness coming out of the right side of the new door to the
power extension harness coming out of the right top side of the dispenser (
Figure
4.13
).
5.
Connect the serial and LED harnesses from the door to the left side connections
on the dispenser (
Figure 4.14
).
6.
Make sure the door harnesses on the top are running through the holes on the top
panel. Ensure the harnesses are not pinched or too near the hinges (
Figure 4.15
).
7.
Reconnect the power to the dispenser and follow the start-up instructions in
Section 6 of this manual.
1.
Remove the collar from each of the hinge pins on the back of the new
door using a 3/32” hex wrench. Place the collars and hex wrench
nearby so they are accessible for the next step.
2.
Slide the hinge pin from the new door into the pivot hole on the upper
brackets on the dispenser (
A
on
Figure 4.11
). Place the collar back
on each hinge pin and tighten the set screw on the shaft collars with
the hex wrench (
B
on
Figure 4.11
).
Figure 4.11
Figure 4.12
Figure 4.13
Figure 4.14
Figure 4.15
561 Conversion Kit Instructions
24-4001-0004
56x Conversion Kit Instructions
24-4001-0005
77x Conversion Kit Instructions
24-4001-0007
