6
5.3 Dispenser Mounting
5.4 Connecting to Electrical Power
The dispenser is shipped with a 10 A plug. The mating wall receptacle must match the amperage rating of
the dispenser. If the plug on the dispenser is replaced with an alternate, it must have the same amperage
rating and provide a grounding prong. The dispenser must be connected to a dedicated circuit with the proper
amperage fuse rating.
The dispenser requires single phase 230 VAC. If the line voltage is below 208 VAC or above 248 VAC, a 10%
buck and boost transformer must be used. Operation below 208 VAC or above 248 VAC may damage the
dispenser and cause inconsistent performance. Operation outside the recommended voltage range also voids
all warranties.
Remove the plug from the power cord and feed the cord through the strain relief located at the back of the
dispenser. Tighten the strain relief securely. Reinstall the plug on the power cord and check for continuity on
the plug across both "hot legs" and no continuity between each "hot leg" and ground.
Note:
The voltage drop on the LCD between idle and run modes must not exceed 10 volts between the power
source and the machine. If it is greater than 10 volts then the power supply is inadequate and needs to be
addressed by a certified electrician.
Countertop - Flush Mounting: One method of installation is to set the dispenser directly on a countertop.
If permanently mounting to the countertop, use the mounting information located in the “Diagrams and
Schematics” section of this manual to drill holes in the countertop. Once installed, with side panels removed,
seal the dispenser to the countertop using a bead of clear silicone caulk around the base of the frame.
Countertop - Leg Mounting: Another countertop option is to use support legs that raise the dispenser four inch-
es off the countertop (purchased separately). The legs mount to the same frame locations as the countertop
mounting bolts. This allows easy cleaning under the dispenser and meets most local health department codes.
Base Cart: A roll-around base cart (purchased separately) can be used when a suitable countertop location
is not available or it is desired that the BIBs and syrup pumps be located with the dispenser. If a base cart
is used, the dispenser must be secured to the cart using 3/8”-16 UNC or M8 bolts. Add nuts to fasten bolts.
Failure to do so can result in serious injury should the dispenser fall off the cart. Once installed, seal the dis-
penser to the cart using a bead of clear silicone caulk around the base of the frame.
Risk of Electric Shock
: If the cord or plug becomes damaged, replace only with a cord and plug of
the same type provided by the manufacturer or service agency in order to avoid potential hazard.
CAUTION
Do not connect the dispenser to power at this time.
