FB Jets FEI BAO, Инструкция по сборке

Страница: 41 / 54

41
‰
Make the final steering cable connections as shown in photo 81.
Step 11: Component Board
There are a vast amount of possibilities for mounting equipment into your airframe so the
following is one suggested method. Remember to allow room for the cockpit tubs to sit into the
airframe without interference from tall components on the component board. In the model use
for the production of this manual the receiver, ECU and gear sequencer were mounted on the
fuselage sides next to the tray as the Rafale has many open areas that are well suited for this
equipment. By doing so much of the wiring remains undisturbed if a tray needs to be removed
for other servicing.
The pneumatic retract system in the model is operated by three valves. The first two way valve
controls gear up and gear down, the second two way valve controls the gear doors that stay
open with retracts down, and the third two way valve controls the doors that close with the gear
down. All three servos are connected to an electronic sequencer that is connected to the
retract channel of your receiver.
A suggested layout of components is shown in photo 82. This arrangement allows easy access,
provides good separation between the turbine and receiver electronics and sits low enough for
the cockpit to easily fit on top. A profession looking installation may be had by creating a
graphic overlay on the component boards, see photo 83.
Photo 81