FB Jets FEI BAO, Инструкция по сборке

Страница: 35 / 54

35
‰
Position the nose retract unit into the retract plate from the bottom. The front of the retract
unit should be positioned as shown in photo 70, make sure to check the tiller arm clearance
between the mount, this can be done by moving the retract from up to down position by
hand.
‰
Working carefully to make sure the retract unit stays in this position and aligned equally to
either side of the gear opening, drill one of the holes closest to the forward former. Insert a
bolt into the hole to hold this position.
‰
Proceed to drill the other three holes, making sure to maintain alignment of the gear. Insert
a bolt in each hole as it is drilled.
‰
When all four holes are drilled and you are satisfied with the alignment, remove the retract
unit.
‰
4-40 Allen head bolts and blind nuts were used for this build; drill out each hole to be large
enough for the blind nut. Insert these from the top and snug them down with one of the
bolts. Apply a little CA to the back of the blind nuts sparingly to hold them in place, see
photo 71.
‰
Reinsert the retract unit and bolt in place. Loctite® bolts to blind nuts.
‰
Fabricate two plywood cable guides that will be mounted to the front bulkhead as shown in
photo 72. Route steering cables using an inner section of a Nyrod for a cable guide.
‰
Finial connections to steering servo will be covered in section 10.
Photo 70
Photo 71
Check for clearance