FB Jets Dolphin S
Step 17: Setting of throws
Elevator should be set values shown in table as measured from the center line of the
outboard edge (Tip).
Aileron should be set values shown in table as measured from the center line of the
outboard edge (Tip).
Flap throw set values shown in table as measured from the center line of the inboard edge
(Root).
Rudder throw set values shown in table as measured from the center line of the inboard
edge (Tip).
Nose Steering should be setup with dual rates to the minimal movement to avoid over steer
during takeoff and landings, the prototype was set with low rate with the deployment of
flaps.
D/R Throws
High Rate
Low Rate
Elevator @ Outer Tip
0.7" (18)
0.5" (13)
Aileron @ Outer Tip
0.5" (13)
0. 3" (8)
Rudder @ Outer Tip
0.7" (18)
-
Throws
Flight
Take Off
Landing
Flap @ Root
0
0.6" (15)
1.45" (37)
Crow (Up Air) @ Tip
0
0
0.15" (3.8)
Measurements in braces ( ) are millimeters
Maintenance Tips:
When inverting the aircraft, put a short piece of fuel tube with a plug on the drain fitting.
Cycle the gears before each flying session, checking for binding and proper operation.
Check the struts for play, indicating the clamping set screw needs to be tightened, verify
toe in on main wheels for reliable tracking.
Check all hinged surfaces; i.e. pull on them before each flying session
Check for proper radio operation, slowly cycle all surfaces with the transmitter making sure
they are moving in the correct direction and proper deflection(
Note:
it is easy to lose a
model due to a simple mistake of selecting the wrong model memory in the transmitter)
Check all linkages, use keepers on the quick links
Check wing mounting nuts for tightness
Check Vertical fin clamp bolts for tightness
Check Horizontal fin mounting bolts for tightness
Check Fuel system for leaks
Check all batteries before each flight, setup a routine maintained schedule on your
batteries making sure that they cycle properly for capacity.
Note do not charge LiPo batteries while installed in the airframe, the battery boxes provide
easy removal of batteries for charging.
Congratulations, you have completed construction of your Fei Bao Dolphin S
31
Содержание Dolphin S
