FB Jets Dolphin S, Инструкция по сборке

Страница: 20 / 39

FB Jets Dolphin S

The main tank mounts and UAT tray (Smoke Tank Mounting tray) can be fabricated
from the supplied templates in annex X utilizing 1/8” (3mm) plywood.

Trial fit the main tank as shown previously in the above photo sequence, mark the area on
the front of the main tank where the two plywood mounting straps will be positioned, also
mark the area on the fuselage where the front fuselage main tank mounts will be
positioned. Sand the areas with medium grit sand paper.

Install a blind nut into the back side of the main tank mount, bolt the tank mounting straps
to the main tank fuselage mount.

Position the main tanks to its final place.

Apply Hysol to the fuselage former main tank mount and to the back side of the tank
mounting strap that is bolted to the fuselage main tank mount. Position the fuselage mount
into the fuselage making sure the tank strap is in contact with the front surface of the main
tank, let dry, see photo above.

Repeat step for the other main tank mount and strap, let dry.

Once the glue is dry the bolt can be removed to allow the tank to removed for service work.
Step 5: Final Fuel System plumbing:

Starting with the UAT, the supply line to the UAT is connected to the clunk line of the left
saddle tank,

The vent line from the left saddle tank is connected to the clunk line of the main tank,

The vent line from the main tank is connected to the clunk line right saddle tank,

The vent line from the right saddle tank is connected to the vent fitting that exits the
fuselage.

The check valve fuel filler in connected to the other UAT fitting for system fueling.

The center line from UAT is connected to the fuel pump.

Make sure to safety wire all connections at this time.

If you use plastic wire ties (Ty-raps) to bind the fuel tubes together for a neater installation,
make sure not to over-tighten and pinch down on the flexible fuel tubing.
20