Fayat Dynapac CC1100C VI, Инструкция по эксплуатации, Страница: 178 / 207

Maintenance - 2000h
4812163101_A.pdf 2018-12-14
Coolers
Checking - Cleaning
Fig. Engine compartment
1. Water cooler
2. Hydraulic fluid cooler
2
1
Make sure that the air flow through the coolers (1) and
(2) is unobstructed. Dirty coolers are blown clean with
compressed air or washed clean using a
high-pressure water cleaner.
Blow air or direct water through the cooler in the
opposite direction to that of the cooling air.
Take care when using a high-pressure water jet.
Do not hold the nozzle too near the cooler. Take care when using a high-pressure water jet.
Do not hold the nozzle too near the cooler.
Wear protective goggles when working with
compressed air or high-pressure water jets. Wear protective goggles when working with
compressed air or high-pressure water jets.
Emulsion tank - Draining
1
2
3
Fig. Pump system
1. Water pump
2. Hose clamps
3. Draining hose
The tank is drained by first opening the rear cover.
There is a water pump (1) on the right-hand side,
inside the cover. Loosen the drainage hose (3) located
on the adapter by loosening the hose clip (2).
Turn the drainage hose downward and outward, place
a container below this on the ground and let the water
drain out.
When cleaning the tank, see Water tank - Cleaning.
The Emulsions tank is made of plastic
(polyethylene), and is recyclable. The Emulsions tank is made of plastic
(polyethylene), and is recyclable.
Remember that there is a risk of freezing during
the winter. Drain the tank, pump, filter and lines,
or mix antifreeze in the water. Remember that there is a risk of freezing during
the winter. Drain the tank, pump, filter and lines,
or mix antifreeze in the water.
164