Fayat Group DYNAPAX DRP45DX, Инструкция по эксплуатации, Инструкция по обслуживанию

Страница: 56 / 118

4. Turn the ignition key to position “I”.
ð
The warning buzzer sounds.
5.
The starter switch is designed with a re-start
lock. The ignition key must first be turned
back to position “0” before a new starting
attempt can be made.
NOTICE!
Components may get damaged!
– Starting attempts should not exceed 30
seconds uninterrupted or max. 3 times
for 10 seconds. Then allow the starter to
cool down to ambient temperature.
– If the engine has not started after these
attempts, determine the cause.
Turn the ignition key through position “II” to position “III”.
ð
The starter cranks the engine.
The warning buzzer must stop.
6. If the warning buzzer does not stop after the engine has
started:
n Park the machine safely Ä Chapter 6.4 ‘Parking the
machine in secured condition’ on page 59 .
n Check the engine oil level; top up if necessary Ä Chapter
5.3.1 ‘Checking the engine oil level’ on page 50 .
n If necessary, contact our Customer Service.
7. Run the engine warm for approx. 1 to 2 minutes in idle
speed.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while before
starting work. Do not operate the engine
immediately under full load.
B-ELE-0070
Fig. 43
B-ELE-0072
Fig. 44
Operation – Starting the engine
DRP45DX 56