Fayat Group DYNAPAC CC1300C, Инструкция по эксплуатации

Страница: 130 / 134

Maintenance - 2000h
4812162101_D.pdf 2021-12-14
Replacing the fuel filter
Fig. Engine compartment
1. Fuel filter
1
Place a container underneath to collect fuel that
runs out when the filter is released. Place a container underneath to collect fuel that
runs out when the filter is released.
Screw off the fuel filter (1). The filter is of the
disposable type and cannot be cleaned. Hand in to a
waste disposal station.
Refer to the engine manual for detailed
instructions when replacing the fuel filter. Refer to the engine manual for detailed
instructions when replacing the fuel filter.
Start the engine and check that the fuel filter is tight.
N.B. Under no circumstances may new fuel filters be
pre-filled with fuel before assembly due to the
demands on the cleanliness of the fuel system. Use
the hand pump on the fuel prefilter to fill from the
machine's fuel system.
Drum - Oil change
Fig. Drum, vibration side
1. Drain plug
1
Take great care when draining the fluid. Wear
protective gloves and goggles. Take great care when draining the fluid. Wear
protective gloves and goggles.
Place the roller on a level surface and drive it slowly
until the drain plug (1) is straight down.
Switch off the engine and activate the parking
brake. Switch off the engine and activate the parking
brake.
Place a receptacle that will hold at least 7 liters
(7.4 quarts) under the plug. Collect the oil and
dispose of it properly. Place a receptacle that will hold at least 7 liters
(7.4 quarts) under the plug. Collect the oil and
dispose of it properly.
Remove the plug and allow all the oil to run out. See
under the heading 'Every 500 hours of operation' for
filling oil.
120