Fayat Group DYNAPAC CC1300C, Инструкция по эксплуатации

Страница: 117 / 134

Maintenance - 1000h
4812162101_D.pdf 2021-12-14
Replacing the pre-filter
2
3
Fig. Engine compartment
1. Pre-filter
2. Hose clamps
3. Bolts
1
Activate the parking brake.
Switch off the engine and remove the plate on the left
side of the frame (at battery disconnector) by releasing
the three bolts (3).
Release the hose clamps (2) with a screwdriver.
Place a container underneath to collect fuel that
runs out when the filter is released. Place a container underneath to collect fuel that
runs out when the filter is released.
Remove the pre-filter (1) and hand in to a waste
disposal station. This is a disposable filter and cannot
be cleaned.
Fit a new pre-filter and tighten the hose clamps.
Start the engine and check that the pre-filter is tight.
Ensure good ventilation (air extraction) if the
diesel engine is run indoors. Risk of carbon
monoxide poisoning. Ensure good ventilation (air extraction) if the
diesel engine is run indoors. Risk of carbon
monoxide poisoning.
Hydraulic fluid reservoir - Draining
Fig. Left frame side
1. Drain plug
1
Condensate in the hydraulic tank is drained via the
plug (1). This should be done when the roller has
stood still for some time, e.g. during the night.
Be very careful during draining. Do not drop the
plug or else all the hydraulic fluid will flow out. Be very careful during draining. Do not drop the
plug or else all the hydraulic fluid will flow out.
Drain as follows:
Place a container under the plug (1). Loosen and allow
any condensate to run out. Tighten the plug.
107