Fayat Group CP1200, Инструкция по эксплуатации, Страница: 75 / 86

Revision History
08/01/2023 4812325556EN 71
Replace the hydraulic oil filters
Hydraulic filters are located on the right side of the engine
compartment
.
TAKE CARE OF THE ENVIRONMENT: All the
used oil shall be properly stored for
subsequent disposal. Do not dispose of oil on
the ground, sewage system or other place
which can harm the environment. The filter is
disposable and cannot be cleaned.
1. Open the hydraulic oil tank cap.
2. Clean carefully the sealed surface on the filter holder.
3. Apply a thin layer of clean hydraulic oil on the rubber gasket
of the new filter.
4. Fit manually the filter, first until the filter gasket manages
to reach the holder. Next, tighten it with one more turn.
5. Check the hydraulic oil level on the sight glass (2) and
adjust, if necessary.
6. Turn on the engine and check if the filter is well sealed.
Check the tires air pressure
To check the pressure, use an air pressure gauge. The
pressure in all the tires must be the same.
To know the recommended pressure values, refer to the
"Technical Specifications" section.
The machine can be equipped optionally with the
tire pressure adjustment system (Air on the Run).
NOTE : For machines with the Air on The Run system, the tires
should be emptied at the end of the operation for 3 - 5 seconds,
so that an auxiliary blow-off of the dryer filter is carried out.
When replacing the tires, it is important that all of
them have the same original diameter and width;
otherwise they can slide into the wheel or make their
installation impossible.
Fig.
– Filters
Fig.
– Wheel
1. Air valve
1