FATEK Automation Corp.
www.fatek.com
3
d. LED display:
i.
Red light on: Indicating the device is power up.
ii.
Green light blinking: Indication the device is in pairing. Or the wireless
communication signal of slave device is poor.
iii.
Green light on: Indicating the slave device can successful link with the
Master wirelessly.
iv.
Green light off: Indicating link between slave device and Master device is
failed. This situation only happens in one to one mode. It will never
happen in broadcasting mode.
v.
Red light blinking: Indicating the device is receiving wireless Data.
2. Power on
When a FBs-CMZBR is powered, it enters Working mode in which it will wirelessly
transparently transmit the data received from wired interface. In contrast to the
Working mode, there is a Configuration mode which will be detailed further in
later section.
a. RS485 Type
i.
Connect DC power wire to the green connector shown above. Please
notice the +/- polarity. The input voltage ranges from 7 to 24 volt. When
the power is applied to FBs-CMZBR, the green light in opposite side
would go on or go flashing depending on the configured mode
(Master/Slave).
ii.
Connect RS485 D+ and D- wire to the 5 hole green connector show
above and fasten screws. Then the device is ready to go.
b. RS232 Type
i.
Plug RS232 cable to RS232 connecter shown in the above picture.
ii.
Plug Power Adapter to DC Jack. The supply voltage ranges from 7 to 24
volt.
c. FBs-CMZBR was defaulted to be Master and green light is always on after
power-up. Then FBs-CMZBR will radio received message to all other power-on
FBs-CMZBR.
