KIC551
K I C 5 5 1 U s e r M a n u a l
44
© 2 0 2 1 F a s t w e l V e r . 0 0 3
Electrostatic Sensitive Device (ESD)!
The CompactPCI module contains electrostatic sensitive components. The following precautions
should be complied with in order to avoid damaging the module:
▪ Prior to touching the module, discharge any static charge from your clothing, and also discharge
any charge from the tools prior to their use.
▪ Do not touch electronic components or connector pins.
▪ If possible, always work with the board in workplaces protected against static electricity
3.7.2 Procedure of KIC551 installation
In order to install KIC551 into the system, follow the below procedure:
1. Make sure you have followed the safety requirements listed in the previous subparagraph.
Attention!
Failure to follow the instructions below may damage the module and result in system malfunctions.
2. Prior to installation make sure that all the necessary module settings are made in accordance
with the subparagraph 3.9.
Attention!
The subsequent operations should be performed with care to avoid damaging both KIC551and
other system devices.
3. To install KIC551 the following actions should be performed:
▪ Prior to installation make sure that the system power is off.
Attention!
While performing this operating,
do not apply force
when you insert the module's connector into
the backplane’s connector. Use the front panel’s handle to install the module into the connector.
▪ Carefully insert the module into the desired connector, sliding it along the guiderails until it
touches the backplane connector.
▪ Using the front panel handle, slide the module into the backplane connector. The module is
considered to be completely inserted when the handle closes with a snap.
▪ Fix the module to the front panel of KIC551 using two retention screws (see Fig. 1.3, Fig. 1.4).
▪ Connect all necessary external interface cables to the module.
