17
Warning
Warning
Warning!
Install the XTT filter disk (72) nearest the user.
Install the XTT filter disk in the disk holder as shown in Fig. 7.
Introduce the clean XTT filter disk again into the disk support (75).
Screw in tight again the covering plate (98).
Hold the disk support in such a way, that the covering plate (98) shows in direction of the tripod.
Push the disk support, beginning from the foot side, into the gap, so that the flap (96) slides in the gap of the
covering plate.
Now the XTT filter disk press the micro-switch (97) into for the BreakSafe protection and the electri
cal circuit is closed. Therefore the XTT-filter disk is secured with BreakSafe.
Turn the screws (74) into and place the acrylic sheet lounger (1).
For replacement of the high pressure burners please turn to your specialized dealer or to the manufacturer of the
unit.
No responsibility will be taken over, whenever other than the genuine high pressure burners are installed.
6.3 Exchanging the illumination light (78, picture 3)
Take up the acrylic sheet lounger (1) on the foot a little bit, and pull away thereunder to the front direction the small
covering plate (57, picture 4). Then turn the illumination light (78) in any direction you with to for about 90 degrees,
until the contact pins (80) in the slot of the holder (81) are visible. Pull out the light. Hold the new bulb horizontally,
so that the contact pins lay horizontally one behind the other. In this position press the light bulb into the holder. Turn
the bulb for about 90 degrees, until the holder engages into. Place on again the covering plate (57).
6.4 Exchanging the Filter Mats
The air for cooling the unit is fed through micro filter mats on entry to the unit. Fluff, hair, dust particles, etc. are
filtered out in the filter so that it is only necessary to clean the components inside the unit e.g. such as filter plates
infrequently. The particles filtered out eventually clog the filter after extended use and thus reduce the effectiven-
ess of the cooling of the unit. Therefore the filter mats should be renewed from time to time to avoid the unit
overheating. The interval between changes is dependant on the operating time and the amount of dirt.
Check up the filters in any case every 200 hours of operation. If the pores of the filters are half
Blocked, the filter must be exchanged.
Only use original filter mats from your specialist dealer or unit manufacturer.
•
Exchanging the Filter Mats of the footrack (picture 4)
Take up a little bit the acrylic sheet lounger (1) at the foot and pull away thereunder to the front direction the
small covering plate (57). Inside of the covering plate the filter mat (82) is fastened with strip fastener. Take
away the filter mat and place on again the new filter mat.
•
Exchanging the Filter Mats of the tanning arm (picture 3)
Remove the waved covering plate (83) on the respective tanning arm. For this purpose, push it in longitudinal
direction, until it slides with its flaps out of the large covering plate (66). Then pull out the wire clip (85), with
which the filter mats (86) are being supported. Remove the old filter mat and insert the new filter mat. Insert
again the wire clip. Place again the covering plate (83).
7 ADVICES
•
Replacement of the high pressure burner
The performance of the high pressure burner gradually reduces without this being visually noticeable. You
must level this out with a longer sunbathing time. uwe recommends to exchange the high pressure burner after
approx. 400 hours of operation.
•
Pipeframe
The two feet of the pipeframe (2) showing in direction of the assembly plates can be taken away one by one.
So that for service jobs you can easily reach the assembly plates, without having to disassemble the unit.
