Fast BW500, Руководство по эксплуатации и обслуживанию

Страница: 54 / 112

Break-In
Page 48
HYDRAULIC DRIVE PUMP (OPTIONAL)
manual carefully to learn how to operate
the machine safely and how to set it to
provide maximum field efficiency. By fol-
lowing the operating instructions in con-
junction with a good maintenance
program, your sprayer will provide many
years of trouble-free service.
Break-In
Perform the following steps on a new
sprayer:
A.After 1 hour of operation:
1.Tighten all wheel lugs to 135 lb/ft of
torque.
2.Tighten all other fasteners and hardware
to required torque.
3.Check that no chemical or hydraulic
lines are being pinched or crimped. Re-
route as required.
4.Check that all nozzles and placement
components are clean and working prop-
erly. Clean as required.
5.Check that the pump is functioning prop-
erly. Adjust as required.
6.Lubricate all grease fittings.
B.After 5 hours of operation:
1.Tighten all wheel lugs to 135 lb/ft of
torque.
C.After 10 hours of operation:
1.Tighten all fasteners and hardware to
required torque.
2.Check chemical and hydraulic line rout-
ing.
3.Check that all placement components
are clean and working properly
D.After 50 hours of operation:
1.Tighten all wheel lugs to 135 lb/ft of
torque.
2.Then follow normal servicing and main-
tenance schedule as defined in Mainte-
nance Section.
Pre-Operation Checklist
Efficient and safe operation of the Fast
sprayer requires that each operator reads
and understands operating procedures
and all related safety precautions outlined
in this section. A pre-operational checklist
is provided for the operator. It is important
for both personal safety and maintaining
the good mechanical condition of the
sprayer that this checklist be followed.
Before operating sprayer, check the fol-
lowing items:
1.Lubricate machine per schedule outlined
in “Maintenance Section”.
2.Use only a tractor of adequate power
and weight to operate sprayer.
3.Be sure that machine is properly
attached to tractor. Be sure that a mechan-
ical retainer is installed through drawbar
pin and safety chain is installed.
4.Inspect all hydraulic lines, hoses, fittings
and couplers for tightness.
5.Check tires and verify they are inflated to
specified pressure.
6.Calibrate sprayer if at start of season or
a new sprayer rate is being used.
7.Check condition and routing of all fluid
hoses and lines. Be sure that all lines are
routed in large arcs. Replace any that are
damaged. Re-route those that are rubbing,
pinched or crimped.
8.Check placement components. Remove
and replace any that are worn.
9.Remove all entangled material.