Fast BW500, Руководство по эксплуатации и обслуживанию

Страница: 51 / 112

Sprayer Accessories
Page 45
HYDRAULIC DRIVE PUMP (OPTIONAL)
IMPORTANT: The storage slots for the
hydraulic hoses should ONLY be used
when sprayer is disconnected from the
tractor and being stored. Hydraulic hoses
MUST always be connected to tractor
during transport of sprayer.
Valve Block
1 - Replace This Wire Coil and Open Cen-
ter Bypass Valve With Plug For Closed
Center Hydraulics
Sprayer Accessories
Make all required electrical connections
for sprayer accessories. Refer to the
“Accessories” section of this manual for
proper instructions on electrical connec-
tions.
Unhitching Sprayer From Tractor
CAUTION
DO NOT stand between the tractor and
sprayer when hitching or unhitching
the sprayer unless tractor engine is
STOPPED and parking brake is applied.
WARNING
Before disconnecting the PTO shaft,
make sure that the tractor motor has
stopped turning before getting off the
tractor.
1.Park sprayer on a firm, level surface.
Block both sprayer wheels to prevent any
unexpected movement when the sprayer
is unhitched from the tractor.
2.Shut down and lockout the power
source. Refer to “Power Source Shutdown
Procedure” on Page 3 of this manual. Fol-
low these procedures to correctly lockout
the power source.
3.Remove the pin and clip from the jack
mount and remove the jack from the
stored position on the sprayer frame.
1 - Pin and Clip
2 - Jack In Stored Position
4.Position the jack onto the mounting hub
on the sprayer hitch. Align the holes in the
jack with the holes in the mount and insert
the pin and clip to secure the jack in place.
5.Turn the leveling crank on the jack until
the hitch begins to rise up off the tractor
drawbar.
2
1