Fasep RGU300.ECO, Инструкция пользователя

Страница: 5 / 21

7
ALL WORK ON THE ELECTRICAL SYSTEM, INCLUDING MINOR OPERATIONS , MUST
BE CARRIED OUT BY PROFESSIONALLY QUALIFIED PERSONNEL

Check that the mains supply is the same as that shown on the registration plate.

Connect the cable to a plug that conforms with European norms or to the norms of
the country in which the machine used.
The plug must have an earth terminal.

Check that the earth connection is effective.

The machine must be connected to the mains through a multipole isolating switch
which conforms with European norms and with contact openings of at least 3 mm.

Check that the multipole connector on the electrical board is correctly connected.

When the machine is connected switch it on and check the correct direction of rotation;this should be as shown by the arrow on
the motor unit.

If the rotation is reversed,reserve the two wires in the connection plug.

If the machine behaves abnormally,immediately press the emergency button and switch off the main switch and check the
section “Malfunctions:causes and possible remedies” in the instructions Manual.
THE MANUFACTURER DOES NOT ACCEPT ANY RESPONSIBILITY FOR THE FAILURE TO OBSERVE THE ABOVE
MENTIONED INSTRUCTIONS.
SAFETY
WARNING!
Do not press on the cable of
the remote control system
may fall,
cable ıs protected by spıral
and sprıng ıncase of droppıng
and smashıng parts.
The direction of movement of the mirror
group
a) The direction of movement of the mirror foot
b) Gear and direction of movement of the rail
system
c) Emergency stop button
Fig.8
Fig.9
Fig.10
CLAUSE 5