Then adjust the
Values
by pressing the
buttons. For direct access, press the
COLOR
button, then enter the value on the keypad
such as
150
.
Tint can be accessed by pressing:
Then adjust the
Values
by pressing the
buttons. For direct access, press the
TINT
button, then enter the value on the keypad
such as
150
.
Detail can be accessed by pressing:
Then adjust the
Values
by pressing the
buttons. For direct access, press the
DETAIL
button, then enter the value on the keypad
such as
7
.
Noise Reduction
can be accessed by press-
ing:
Then adjust the
Values
by pressing the
buttons. For direct access, press the
N. R.
button, then enter the value on the keypad
such as
5
.
Adjusting Detail
The Detail and Noise Reduction settings have
been optimized for most sources. However, the
viewers tastes and the types of software used
may require making adjustments of these set-
tings to fine tune the image. Theses controls
are very effective to either increase detail or to
help clean up poor quality video material. It is
recommended that adjustments be made in
small increments until the desired results are
achieved.
It is important to not use too much Detail as the
image will start to look artificial.
RS232 CONTROL
Connector:
DB-9 Female
Baud rate:
9600 default, 8 bit,
1 stop bit and No Parity
(Adjustable 4800, 9600, 19,200)
Pin Configuration:
Pin 5 = Ground
Pin 3 = Rx
Pin 2 = Tx
All commands to the DVP5000 are sent using
ASCII text strings.
Note: A command must start with the string
header DVP5000 or DVP5000U.
Following the header, a comma is used to
delimit the header from the command. All the
commands with their descriptions will be listed
below. All the text strings are terminated with a
carriage return (0x13). The header and com-
mand are not case sensitive.
Since the picture settings are Input specific, the
input to be used, i.e. Video, Y/C or YPrPb, must
be selected first before adjusting and storing
settings.
EXAMPLE:
DVP5000,x,b128,C175,K128,N10,d6 (0x13
or cr)
12
RS232 INSTRUCTIONS
TINT
M PIP
DETAIL
STOP
N.R.
PAU
