21
Revision date: 09.25.18
115277
6
Assemble and Install Nutrient Supply Manifold
15. Assemble the four (4) valve assemblies as shown.
16. Wrap the threads of each 111074 adapter four or five times with the
WR1095 thread sealing tape. Wrap in a direction that will not loosen when
installed in the threaded elbows of the supply manifolds.
17. Take one valve assembly and thread it into the threaded elbow fitting
at the end of a manifold assembly. Tighten until snug. Repeat to install
all remaining valve assemblies. Valves will all be at the same end when
manifolds are attached to the frame.
AC2804
111074
113535
111698
Clamps
18. Snap the upper manifold and first lower manifold assemblies into place.
Measure the length needed for the first vertical pvc pipe and cut a piece of
1" pvc pipe to that length. Remember to allow enough length for the pipe to
connect the two supply manifolds.
Do not cut the pipe too short.
Dry fit
the pipe before adding pvc primer and cement.
Upper Manifold Assembly
Lower Manifold Assembly
Step 18:
Measure distance needed to
connect manifolds. Pipe must be long
enough to insert into each fitting.
ASSEMBLE AND INSTALL NUTRIENT SUPPLY MANIFOLDS—CONTINUED
