10
10
115277
Revision date: 09.25.18
2
1. Using the assembled frame as a bench, place one channel on a bench or
saw horses.
2. Take the 112509 adhesive and attach the plain end cap (no outlet–111030)
to the channel. Coat the end of the channel with adhesive
before
you
install the end cap. See photos A & B. Also, apply adhesive to the
connection on the inside of the channel. See photo E. Repeat for all
channels.
ASSEMBLE THE GT80 CHANNELS (continued)
3. Next, attach the 111029 end caps (with outlet). Coat the channel end with
adhesive
before
you install the end cap. See photos C & D. Also, apply
adhesive to the connection on the inside of the channel. See photo E.
Repeat for all channels.
4. Carefully flip all channels over so the bottom is facing up. Apply adhesive
along the edges to secure and seal end caps to each channel. Photo F
shows an end cap with an outlet as an example.
NOTE:
Coat all edges and seams of the end caps to prevent leaks.
5. Allow the adhesive to dry before moving the channels or testing the
system.
Apply adhesive in a well-ventilated area. Read the
container information for additional precautions.
ATTENTION:
Attach one 111029 end cap (with outlet) and one
111030 plain end cap to each GT80 channel.
A
B
C
D
open
top-inside
channel
bottom
E
F
Assemble Channels
