30
Revision date: 03.08.17
MOTOR & DRIVE SHAFT COMPONENTS (continued)
End Wall Power Vent
7. Add one (1) FA2902 u-bolt plate, two (2) FAME16B
flat washers, and two (2) FALF35B lock nuts.
8. Using a 1/2" wrench or socket and ratchet, tighten
nuts until snug.
9. Move to other end of vent and repeat steps to attach
u-bolt to that end vent rack.
10. After installing both u-bolts, carefully lift vent panel
one more time to ensure that u-bolt stops panel
before it drops out of vent sash.
NOTE:
Reposition u-bolt if needed to prevent panel
from dropping out of vent sash.
11. Reinstall the 111602PLG hinge stopper removed in
Step 2.
12. Check vent operation by opening the vent with an
assistant and slowly allowing it to close.
NOTE:
Use as many assistants as needed to keep
the vent frame straight during the process.
13. With vent closed, return to each vent rack drive and
tighten the two (2) set screws using a 4mm hex
wrench.
Consult "Motor Care and Maintenance" page towards the
end of these instructions for additional motor details.
