FarmTek Growers supply GrowSpan 106306PC, Руководство по установке

Страница: 20 / 51

GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
20
Revision date: 06.07.18
END PANEL INSTALLATION
After the end wall framing is attached to the greenhouse,
attach the polycarbonate panels to the end wall framing.
The steps that follow describe one way to complete the end
wall panel installation.
The materials and parts needed to assemble the end
panels include:
• Polycarbonate Panels and White Vent Tape
• Aluminum U-Channel Profile (#104213)
• Aluminum 8' H-Channel Profile
• Tek screws (#FA4484B)
• Neo-bonded Galvanized Washers (#102921B)
Read the following information before starting:
• H-Channel Profile is used to join two (2) separate
polycarbonate panels at the seam.
• Tek Screws and galvanized washers are used to
secure aluminum channel and panels to end wall
frame.
• Install the polycarbonate panels with the UV-protected
side to the outside. Mark this side with a marker if
needed after removing the protective film.
ATTENTION: The protective film must be removed
from the polycarbonate panels. Allowing the film to
remain intact and in direct sunlight will make the film
difficult if not impossible to remove.
• During preparation, rest the edges of the panels on
cardboard or other material to protect them from dirt
and damage.
• Seal the bottom edge of the panels with white vent
tape.
• Consult the Polycarbonate Panels diagrams (Quick
Start section) for the location and lengths of each
panel. The diagrams are located at the back of these
instructions.
ATTENTION: Panels must be position as shown on the
panel diagrams. Using a panel in the incorrect place can
affect the placement of subsequent panels. In addition, the
amount of aluminum profile used between panels and to
finish the panel edges may not be adequate if additional
seams are created. Begin at the door end of the building.
NOTE: Install all accessories (fans, vents, heaters, etc.)
after installing all polycarbonate sheets.
Complete the following general steps to install the end wall
panels.
1. Consult the panel location diagrams, select one
polycarbonate panel, begin at the edge of the opening
for the double door, and work to the outside edge of the
end wall.
See the X in the diagram below for the first panel.
NOTE: Remove the protective film. When needed, an
upper panel is cut to length after attaching it to the end
wall frame and rafter.
Always remove the protective film and mark and install
the UV-protected side to the outside of the greenhouse.
EXCESS
TRIMMED AND
USED HERE
EXCESS
TRIMMED AND
USED HERE
Dashed line and small arrows (above) show where to install white
vent tape.
X
Mark UV Side
X
2. Apply white vent tape to the bottom of the lower panel
and then install the aluminum U-channel profile to the
edge of the panel adjacent to the door as shown on the
Polycarbonate Panels diagram.