88
115554 Revision date: 01.27.20
6
INSTALL PUMP AND SUPPLY TUBE
1. Slide lid back and set pump in
reservoir. Center pump under
supply valve and measure from
top of pump to in-line valve to
estimate supply tube length.
2. Cut a section of 3/4" tube to
length and check fit. Trim if
needed.
NOTE:
Pump should sit on
bottom of reservoir with no stress
on tube or fittings once tube is
connected.
3. Take pump and slide supply tube
(cut in step 2) onto pump fitting.
Add a ratchet clamp.
ATTENTION:
Pump fitting and
o-ring are included with pump.
Install correct pump fitting before
installing tube.
4. Gently secure clamp using a pair
of pliers.
Do not over-tighten.
5. Set pump in reservoir.
6. Slide a ratchet clamp over supply
tube connected to pump.
7. Slide supply tube onto end of in-
line valve.
Install Pump and Attach Supply and Drain Tubes
