11
CHICK-INN
Revision date: 12.19.07
NOTE:
Allow a few inches to remain between the end
of the cover and the ratchet. Temporarily secure the
cover to the frame if needed to prevent it from moving
in the wind.
Do not leave a loose cover unattended.
8. Center the cover on the frame front to back and side to
side.
9. In the front and rear hems, locate the cover straps.
Using the straps as guides, fasten ratchets to the
outside of the end rafter legs using a Tek screw.
10. Thread the strap end into each ratchet and slightly
tighten.
NOTE:
It may be necessary to remove excess strap if it
binds up in the ratchet.
11. Using the cover conduit as a guide, attach the
remaining ratchets to the interior rafter legs at the
proper height. Fasten ratchets to the outside of these
rafters using Tek screws.
12. Cut a slit through the main cover pocket at the rafter
position where the ratchets are installed. Insert a 3'
section of strap though the slit and around the cover
conduit for each ratchet.
13. Thread the strap ends into a ratchet and slightly
tighten.
NOTE:
It may be necessary to remove excess strap if it
binds up in the ratchet.
14. Repeat the steps for the remaining ratchets.
15. Using additional help (if needed) tighten the cover
beginning with the ratchets along the sides of the
shelter frame. Tighten all ratchets evenly.
NOTE:
Loosen the ratchets if need to center the cover
or remove excess strap and retighten.
16. With all side ratchets tightened, tighten the end ratchets
to secure the bonnet portion of the main cover.
17. Read the care and maintenance information that
follows.
INSTALL COVER (CONTINUED)
Cover conduit in cover
Cover conduit in cover
