Farmi Forest VALBY CH140 L, Эксплуатация, техническое обслуживание и запасные части

Страница: 5 / 40

CH140 L
5
3.SAFETY
3.1.GENERAL SAFETY
Do not operate this machine until you have read and understood the manual page
by page.
The owner of this machine is responsible for instructing all operators and support
personnel in the operation and safety precautions of this chipper. Proper training
prior to operating the chipper is obligatory.
IMPORTANT!
D
Inform everyone who works with the chipper about the risks and how they can avoid accidents.
D
Before the chipper is running, ensure that the working place is clear of any bystander within a
minimum risk zone of 100 ft. (30 meter).
D
Do not let children or untrained persons operate the chipper.
D
Always have the chipper mounted on the 3---point hitch of the tractor. Otherwise the chipper will tip
over.
D
There is a serious crushing hazard between tractor and chipper. Do not go between the tractor and
the chipper in any case, for example when you are mounting the chipper to the tractor.
D
Check that the covers of the universal shaft are in their place and the ransmission chains are fastened.
D
Safety goggles, earmuffs and a hard hat are obligatory when chipping. Use respirator mask, if
necessary.
D
Do not wear loose clothing, loose sleeves, scarves or long uncovered hair around moving parts of
machinery. Also avoid gloves of poor condition or with loose fitting, because they might get caught in
the branches.
D
Stay alert! Do not operate the chipper when fatigued, or under the influence of alcohol or drugs.
D
IMPORTANT! Never leave the chipper running and unattended.
D
IMPORTANT! Failure to obey the warnings on the chipper or in the operator’s manual will result in
personal injury and / or death and / or equipment damage.
D
Check the material before you feed it. The material must be free from nails, stones and all other
materials that are not wood, paper or plastic. IMPORTANT! Feeding wire and barbed wire into the
chipper is very dangerous as it might pull in the operator.
D
Make sure that no one is in the path of flying chips. Point the discharge pipe away from windows,
doorways and other areas where people or animals may be.
D
Keep the work area clean so there is nothing to trip over.
D
Disengage the PTO, cut the engine and remove the keys before any maintenance.
D
Use only original parts replacements. IMPORTANT! Do not make any modifications.
D
Check all moving parts. They should be fastened in place, in good working condition and all shields
and guards must be in place.
D
Point the discharge downwind to prevent dust or chips from blowing onto the operator.
D
If a wood jams inside the chipper, cut the engine and wait for all movements to stop before reaching
inside the feed chute.
D
Do not use the chipper indoors when you use it with a the tractor or with the separate hydraulic motor.
It’s possible to use the chipper indoors with the electric motor use.
D
You must be very careful when working indoors. Protect yourself against possible hazards like
exhaust gas by sufficient ventilation, for dust that can catch fire by cleaning your environment
regularly.
D
Always use the lock bolt before and during maintenance on the machine.
D
Place the PTO shaft in the holding device when disconnected from tractor.
Risk of cutting injury or hits by flying debris.
Do not reach into the feed chute for any reason.
Failure to follow these instructions could result in serious injury or death.
DANGER!