Farmi Forest VALBY CH140 L, Эксплуатация, техническое обслуживание и запасные части

Страница: 14 / 40

CH140 L
14
6.TRAFFIC ON PUBLIC ROADS
IMPORTANT!
Prior to every procedure always
recall the general safety
instructions given in chapter 3.
Follow these special instructions to avoid risks
of accidents. Otherwise the manufacturer or
retailer will not assume any liability for
damage.
You shall have full control of the unit in every
situation when driving.
Bumpy driving might damage the chipper / the
feeding device.
Always follow the regulations established by
the law.
6.1.TRANSPORT POSITION
1. Open the pawl lever of the feed chute and turn the
chute aside. Disconnect one end of the control lever
from the valve and lock the chute into transport
position.
2. Turn the discharge chute into transport position.
3. Before driving off, ensure the machine unit’s
appropriate stability and check that the chipper is
firmly connected to the tractor and all fasteners are in
place.
IMPORTANT!
Make sure that the rear lights of the
tractor are visible. Use a separate
light panel, if needed.
7.PREPARATIONS FOR START UP
Do not attempt to operate this
chipper without proper training.
Read and understand the owner’s
manual before operating the
machine.
WARNING
!
Failure to heed the warnings printed on the
chipper or in the operators manual might result
in serious injury or death!
7.1.LIFTING
IMPORTANT!
Prior to every procedure always
recall the general safety
instructions given in chapter 3.
Make sure that nobody will enter
the lifting zone.
DANGER!
Always check before lifting that the
lifting equipment is in order and
use the marked lifting points,
whenever possible. Always use
proper lifting equipment and check
for its sufficient lifting capacity.
CAUTION!
Know the weight of the load and check that the
performance of the lifting equipment will not
be exceeded.
Check the hoisting cables and chains
regularly. Mark any discarded cable and
remove it immediately.
Weight , 530 lbs
240 kg
Fig.3.
CH170 lifting point.
7.2.MOUNTING THE CHIPPER UNIT
1. Mount the 3---point hitch lift bar to the chipper frame.
2. Tighten the nuts with a 1 3/16” or 30 mm wrench to 190
foot---punds (260 Nm).
3. Mount the feeding device to the chipper with a hinge
pin and, from the other side, with two M12x40 bolts
and M12 nuts. See fig. 4. (If you use a hydraulic feeder,
refer to separate manual for instructions on mounting
and connecting the hydraulics.)
4. Connect the discharge chute to the chipper with three
M10 bolts and nuts. Adjust the lid control with the rod.
5. A Power Take---Off shaft (PTO shaft) transfers the
power to the chipper. The chipper has a 1 3/8”
diameter 6 spline PTO hookup.
6. Check for the correct length of the PTO shaft. (Refer to
7.4.)
Fig.4.
D
Turn off the engine.
D
Lower the chipper on its legs on a hard, level surface.
D
Turn the chipper’s axle by hand to ensure that the disk
can turn freely and that there are no foreign objects in
the chipper.